KEMSOL BAC-STOP – Sanitiser & Disinfectant 5L

NATURE MADE ENVIROPASTE Cleaning Paste 550g

GRK3 Green Rhino Auto Dishwasher Powder 4KG

KEMSOL BAC-STOP – Sanitiser & Disinfectant 5L

Overview

A highly efficient, broad spectrum, cationic germicide specifically formulated for post-clean disinfection of machines, floors, and walls in food processing plants and other critical areas.

DIRECTIONS:

MPI Approved C43 & Direct Inspected MPI Multi-site Facilities:

• Open Hard Surface Sanitising: Use at a ratio of 1:100 (10ml per litre, 1% solution) to 1:200 (5ml per litre, 0.5% solution, 500PPM).
• Foot Baths: Use at a ratio of 1:50 (20ml per litre, 2% solution, 2000PPM). Test strip verification recommended to ensure minimum QAC level of 400PPM is maintained.
• Food Plant Area Hard Surface Foam Sanitising: Use at a ratio of 1:100 (10ml per litre, 1% solution).
• Mould and Mildew Control: Use at a ratio of 1:20 to 1:5 (50-200ml per litre, 5-20% solution).

Application Instructions:

1. Clean the surface to be disinfected.
2. Dilute BAC-STOP with water according to the specified ratios.
3. Apply using a water blast (preferably with a foaming nozzle) or brush onto the surface.
4. Rinse off with water after application.
5. For fish processing applications, may be used at 1:200 dilution as a "no-rinse" sanitiser; ensure food contact surfaces are thoroughly drained.

Additional Notes:

• Operators processing only fish may skip rinsing after application, but food contact surfaces must be well drained.
• For other operators, food surfaces must be rinsed with potable water before production resumes.
• Verify and adjust dilution rates according to site-specific QAC standards and testing programs.
• Suitable for general non-food contact surfaces in a no-rinse capacity.
• Avoid using in Clean-In-Place (CIP) systems to prevent detergent residue contamination.
• Wipe incidental food contact surfaces with a clean, damp cloth or paper towel.

MPI APPROVED C101-87:

• For no rinse sanitising on all food contact surfaces: 200ppm active QAC (2ml per litre of potable water or 1:500 parts potable water).

Non-MPI Approved / Inspected Facilities:

• Dilute with potable water.
• General Hard Surface Sanitising: Use at a ratio of 1:100 (10ml per litre, 1% solution, 1000PPM) to 1:500 (2ml per litre, 0.2% solution, 200PPM) with a minimum contact time of 1 minute.
• Foot Baths: Use at a ratio of 1:50 (20ml per litre, 2% solution, 2000PPM).
• Mould and Mildew Control: Use at a ratio of 1:20 to 1:5 (50-200ml per litre, 5-20% solution).